HUB1
LINK WIRING CENTRE
Omnie 'O' -> Cogs -> General Params -> System Set Up -> Wcentre Settings -> Add Wcentre -> Automatic -> With el.mix -> POP UP: YesTOP TIP: You'll see a Warning pop up that will instruct you to press the U1 button on the Omnie Wiring Centre. See fig. 1
HUB2
LINK WIRING CENTRE
Omnie 'O' -> Cogs -> Install Params -> System Set Up -> Wcentre Settings -> Add Wcentre -> Automatic -> With el.mix -> POP UP: YesTOP TIP: You'll see a Warning pop up that will instruct you to press the U1 button on the Omnie Wiring Centre. See fig. 1

Fig. 1: U1 Pop Up Menu
Once you've pressed U1 on the Omnie Wiring Centre (see fig 2.) the red LED will stop flashing while it communicates with the Control Hub. After a successful communication the red LED on the Wiring Centre will be flashing 3 short flashes and the pop up box will have disappeared from the Control Hub.
NOTICE: If the Wiring Centre gets stuck on the warning pop up and will not connect please check that all the wires have a solid connection. We recommend taking the wires out of the terminal block, winding the terminal block screws to the downward position and reinserting the wires making sure there is a solid connection. If you do this make sure to perform a Modbus Reset before you attempt to connect the Wiring Centre again.

Fig. 2: U1 Button on Wiring Centre
Comments
0 comments
Article is closed for comments.