HUB1
ADD SENSOR
Omnie 'O' -> Cogs -> General Params -> System Set Up -> Wcentre Settings -> Add Sensor -> Manual Mode -> SELECT: Wcentre 1 -> PRESS: TICK -> Add 1 into the box -> PRESS: TICK -> Assignment -> SELECT: room number 1 -> SELECT: TICK -> INPUT: Sensor Serial Number -> PRESS: OKTOP TIP: The sensor LED will stop flashing once connected at this stage
HUB2
ADD SENSOR
Omnie 'O' -> Cogs -> Install Params -> System Set Up -> Wcentre Settings -> Add Sensor -> Manual Mode -> SELECT: Wcentre 1 -> PRESS: TICK -> Add 1 into the box -> PRESS: TICK -> Assignment -> SELECT: room number 1 -> SELECT: TICK -> INPUT: Sensor Serial Number -> PRESS: OKTOP TIP: The sensor LED will stop flashing once connected at this stage
Comments
0 comments
Article is closed for comments.